Noritz CB180DV 180,000 BTU Tankless Water Heater - HCNAC1007-NG

Noritz CB180DV 180,000 BTU Tankless Water Heater - HCNAC1007-NG

Noritz CB180 Combination Boiler is a year‐round, whole‐home solution that delivers hot water to both plumbing and hydronic heating applications. The unit performs at a 95 percent AFUE (Annual Fuel Utilization Efficiency); that is, 95 percent of the fuel consumed goes to heating the water to the preset temperature, as opposed to being lost through the flue.

This fuel‐saving performance meets "Energy Star Most Efficient" standards, meaning that, with the Combination Boiler, you will be able to qualify for various state energy rebates around the country and offset the initial cost. The CB180 has a maximum input Btuh of 180,000 for hot water and 100,000 Btuh for space heating.

• Standard Input: Gas consumption range from 18,000 BTUh to 180,000 BTUh

• Heating Mode Input: Gas consumption ranges from 18,000 BTUh to 100,000 BTUh

• Turndown Ratio: 6.7 (CB199) and 5.6 (CB180)

• Capacity Range: Flow rates of 0.5 GPM up to 9.3 GPM (CB199) and 9.1 GPM (CB180)

• Compact Design: ANSI A21.13/CSA 4.9 certified design that can be wall‐mounted indoors

• Durable Steel Casing with Polyester Coating

• Heat Exchanger: Manufactured with STS 304 stainless steel

• Venting Options: For indoor installation only. Convertible to Single Vent (‐SV) with the use of conversion kit (#SV‐CK‐3)

• Direct Electronic Ignition

• AFUE‐ 0.95(NG) 0.95(LP)

• Temperature Controls: Includes remote thermostat that can precisely adjust the output temperature with the capability to display temperatures in °C; Domestic Mode: 90°F to 140°F, Heating Mode: 100°F to 180°F

• Outdoor Reset Control: Built‐in customizable programming for Energy Savings and Comfort with Outdoor Temperature Sensor (included)

• Power Cord Installation Kit: 6' power cord is included

• Safety Devices‐ Flame Sensor, Overheat Cut off Limit Switch, Gas Leak Detector Sensor, Water Leak Detector Sensor, Exhaust Temperature Sensor, Pressure Sensor, Heating Supply Temperature Sensor

• Internal Pump: Heating Mode: used for primary closed loop. Domestic Mode: used for pre‐heating of internal plate heat exchanger