Greenlee Puller Package with UT8 Ultra Tugger & Mobile VersiBoom - 6805

Greenlee Puller Package with UT8 Ultra Tugger & Mobile VersiBoom  - 6805

Ultra Tugger 8 UT8 Cable Puller 8000 lb

Standard Force Gauge

Mobile Versi-Boom

With elbow and extension

Weldment Adapter 2-1/2in

Weldment Adapter 3in

Weldment Adapter 4in

What Our Experts Think

Q&A

Q: What is the Greenlee 6805 Puller Package used for?
A: It is a high-capacity cable pulling system designed for pulling electrical cable through conduit and cable tray on commercial and industrial job sites.

Q: What is included in the 6805 package?
A: It typically includes the UT8 Ultra Tugger (8000 lb capacity), Mobile VersiBoom, force gauge, wheeled carriage, and adapters for 2-1/2", 3", and 4" conduit setups.

Q: What is the maximum pulling capacity?
A: The system delivers up to 8,000 lb (35.8 kN) of pulling force, with continuous and controlled operation ranges for heavy-duty installs.

Q: What makes the Mobile VersiBoom important?
A: It allows fast, tool-free setup (often under 2 minutes) without anchors or chains, improving portability and jobsite efficiency.

Q: What type of cable does it support?
A: It is designed for electrical power cable pulls, especially in conduit systems requiring high tension and controlled speed.

Q: What is the pulling speed?
A: Depending on load, speeds range from about 9 ft/min (no load) down to ~6 ft/min at full 8,000 lb load.

Q: What power does it require?
A: It typically runs on 115V, 20A electrical supply, common on industrial job sites.

Q: What does “UT8 Ultra Tugger” mean?
A: It refers to Greenlee’s 8,000 lb-rated hydraulic/gear-driven cable puller platform designed for heavy-duty electrical installations.

Maintenance Tips

• Inspect wire rope/rope regularly: Check for fraying, kinks, or flattening and replace immediately if damage is found.
• Check hydraulic system (UT8 Tugger): Monitor hoses, fittings, and seals for leaks; maintain proper hydraulic fluid levels.
• Lubricate sheaves & bearings: Keep boom pulleys, sheave wheels, and pivot points lightly greased for smooth pulling action.
• Verify VersiBoom stability: Ensure outriggers, base locks, and mast supports are fully secured before each pull.
• Inspect capstan drum: Remove wire buildup and ensure smooth, even rope wrap to prevent slippage or uneven pulling.
• Test emergency stop & controls: Confirm all control switches and safety stops function properly before operation.
• Check alignment: Ensure tugger, boom, and sheave path are aligned to reduce friction and cable damage.
• Tighten all fasteners: Regularly check bolts, pins, and mounting hardware for vibration loosening.
• Avoid overload operation: Stay within rated pulling capacity to protect hydraulic motor and structural components.
• Store properly after use: Clean equipment and store in a dry, covered area to prevent corrosion and contamination.