Hooke Road Front Bumper & Rear Bumper(05-11 Toyota Tacoma) - HE.4008&HE.4022
Fits for 2005-2011 Toyota Tacoma ModelsBumper weight: about 75 lbs;9500 lbs rated,3/4'' D-rings included; 120w high power LED flood spot combo light bar(22 inches) included; Heavy-duty, high tensile 11 gauge (1/8 inch) & 10 gauge(9/64 inch) steel construction; Tough bumper w/skid plate provides superior protection to your front end components; D-rings w/ rubber isolators to provide extra protection against abrasion; Delicate hollowed-out honeycomb design in both sides; Aggressive, off-road styling; Textured black powder coat finish; Simple bolt-on installation
Please Double-check the distance between front bumper edge and fender below to Purchase What you Like.
G4022 Rear Bumper
Fit for 2005-2011 Toyota Tacoma Models; Not Compatible with Blind Spot Sensors
Bumper Weight: About 67 lbs
One-Piece, Fully-Welded Structure; Provides Adequate Front-End Protection
2 x 18W LED Floodlights Included
Includes Holes for Mounting License Plate in the Middle of the Bumper. Pre-Formed Cut-Outs to Accommodate Factory License Plate Lights
Integrated Corner Side Steps for Convenient Truck Bed Access
Works with Factory Receiver Hitches
Compatible with Factory Back-Up Sensors; Pre-Drilled Holes for Sensors to Fit Properly(Professional Installation is Recommended)
Included 3/4 Inch D-Rings Which Can Support Up to 9,500 lbs; Rubber D-Ring Isolators are Included
Heavy Duty 11-Gauge(1/8 Inch) Steel Construction
Textured Black Powder Coat Finish
Simple Bolt-On Installation with Detailed Instruction
What Our Experts Think
-
Full matching bumper set (front + rear) for 2005–2011 Toyota Tacoma models
-
Built from high-strength steel for maximum protection at both ends
-
Textured black powder-coated finish resists corrosion, wear, and impact
-
Front bumper includes LED light provisions and winch compatibility
-
Rear bumper features LED light cutouts and D-ring mounts for recovery use
Q&A
Q: Does this set fit all 2005–2011 Tacoma trims?
A: Yes — it’s engineered to fit most trims within that year range, excluding specialty sensor or trim variations
Q: Are the lights, D-rings, and winch included?
A: The set provides mounting provisions for LED lights, D-rings, and winch; the accessories themselves are usually not included
Q: Is installation complicated or does it require modifications?
A: No — both bumpers are designed for bolt-on installation using factory mounting points without major cutting
Q: Will factory sensors or towing hardware still function?
A: Generally yes — sensor relocation or adapter use may be required depending on the specific truck’s setup
Maintenance Tips
-
Clean both bumpers regularly to remove dirt, salt, and debris
-
Apply protective coatings or sprays to maintain surface integrity
-
Inspect and re-tighten all mounting bolts and welds periodically
-
Check LED and wiring connections, as well as D-ring mounts, for proper functionality and security
